NorthStar Navigation NorthStar 8000i - Manual (Page 97)

Northstar 8000i Operation Manual 97
2. The
Bathymetric button shows the current setting. Select the
button if you want to toggle to the other setting.
3. The new setting is shown immediately and stays until you change it
again.
4. When you are finished, select Return.
13.11 Overlay satellite or aerial photos on 3D Chart
If land is drawn on your 3D Chart screen, you can overlay this with satellite photos
or aerial photos if these are available from C-Map for that area.
NOTE: If you pan the 3D Chart screen, or change the azimuth or camera angle, the
photo overlays are switched off automatically to improve the response time of the
display. Just select the Photo Overlay button again to re-display the photo
overlays.
To overlay satellite or aerial photos:
1. Display the 3D Chart screen.
2. The
Photo Overlay button shows the current setting. Select the
button if you want to toggle to the other setting. If it's:
ƒ On, the land areas are overlain by satellite photos or aerial photos if
these are available. You may need to zoom in closer to the land
area to display the photo overlays.
ƒ Off, the land is drawn graphically.
3. The new setting is applied immediately and stays until you change it
again.
4. When you are finished, select Return.
13.12 Synchronize 3D Chart and the chart screen
If you display the Chart screen and the 3D Chart screen side-by-side in two panes
of a page, you can synchronize the two panes to show different perspectives of
the same area.
When the two screens are synchronized, the Chart screen settings are applied to
the 3D Chart screen, not the reverse. For example, if you want to zoom in on the 3D
Chart screen, you must zoom in on the Chart screen; these changes are then
duplicated on the 3D Chart screen.
To synchronize 3D Chart and the Chart screen:
1. Select
Pages. If you:
ƒ don't have a page that shows the 3D Chart screen in one pane and
the Chart screen in the other pane, edit or create a page that shows
these two screens (see "Edit a page" page 26).
ƒ do have a page that shows the 3D Chart screen in one pane and the
Chart screen in the other, select it.
2. Select the 3D Chart pane so that it becomes the active pane. If you
can't see the Sync to Chart button, select Return.
3. The
Sync to Chart button shows the current setting. If it's: