Nortel Networks SRG 50 NN43001-307 - Manual (Page 80)

80 Dialing Plan configuration
CUST 0
FEAT ESN
CDP YES
MXSC 50
NCDP 4
DLTN YES
• Configure the CDP Distant Steering Code (DSC) in LD 87.
> LD 87
REQ NEW
CUST 0
FEAT CDP
TYPE DSC
DSC 50
FLEN 4
RLI 12
To configure the NRS (H.323 Gatekeeper/SIP Redirect Server):
• Create CDP Domain: MO_BO_CDP.
• Create H.323 and SIP endpoints: MO, BO.
• Create Numbering Plan entries in CDP Domain:
— Add 30 for endpoint BO.
— Add 32 for endpoint MO.
For information about configuring H.323 Gatekeeper/SIP Redirect Server,
see IP Peer Networking Installation and Commissioning (NN43001-313).
To configure the SRG:
• Configure DN and BUID as the same number on each of the redirected
IP Phones. For example, DN/BUID = 32XX.
• Set the main office VoIP Trunk Access code to 6. For example, main
office VoIP trunk access code = 6.
• Set the destination code for the VoIP trunk to 6, the same value as the
access code. For example, BUID dialout = 632XX.
The main office access code length is still 0.
• Assign the telephones registered to the SRG (IP Phones or analog
[500/2500-type] telephones) to a different range, such as 30XX, than
the telephones registered to the main office.
SRG users must dial the destination code before the DN when making
a call to a telephone in the main office, whether they are in Normal or
Local Mode. When calling another IP Phone in the SRG, SRG users dial
only the DN, whether they are in Normal or Local Mode. The main office
uses VNR to route SRG DN to the SRG in both Normal and Local Mode.
Nortel Communication Server 1000
Main Office Configuration Guide for SRG 50
NN43001-307 02.02 Standard
Release 5.0 3 December 2007
Copyright © 2005-2007, Nortel Networks
.