Nuvo NV-T2FX - Manual (Page 7)

Front Panel
1. Stand-by LED: This LED (Light Emitting Diode) indicates that the T2 is plugged into an AC power source.
2. Remote Sensor: This IR (Infrared) receiver allows wireless remote control of the T2 functions. This IR input is active, even
when it is used in conjunction with the direct IR input on the back panel.
3. Frequency and Band Display: The display indicates the band AM, FM, or WX (Weatherband)and station frequency, or the XM
station being received.
4. Preset/ RDS Display: This is a display of customized preset information, or RDS (Radio Data Service) information
transmitted with the station's broadcast. NuVoNet allows this to scroll automatically on the Concerto Display Pads (pg. 20).
5. Stereo: This indicates whether the FM signal reception is stereo. No display indicates mono. The T2 software allows an FM
station preset to be set in mono mode (pg. 23).
6. Signal Strength: This indicates the level of signal being received at the tuned frequency. The signal level refers only to AM
or FM band signals.
7. Select Knob: Turning the knob scrolls through the T2 menu options; pressing the knob selects the displayed menu option.
When not in menu mode, the Select knob tunes up and down. Pushing the knob selects the station.
8. Category Up and Down: This function requires the use of the T2 installation software for AM/FM use. The XM categories are
predefined by XM. Categories allow station selection to be set up according to specific listening genres.
9. Numeric Buttons: These buttons are programmable for direct station preset access. Customized alphanumeric strings can be
defined in the setup software (pg. 23). They can also be used for direct frequency tuning for AM/FM or XM station tuning.
These custom strings are displayed on the Display Pads of an integrated Concerto system whenever a preset is accessed.
10. Display Button: This button toggles between RDS information on and off.
11. Memory Button: The memory button provides you with a personal “notepad” to store and recall artist and song information
originating from RDS or XM data being broadcast for future reference.
12. Menu: This button enters and exits the menu mode (pg. 14).
13. Pre/Dir: This toggles between numeric preset selection and direct station input.
14. Source: This button toggles between the available modes, AM, FM, WX (Weather Band), Aux or XM input on the XM
versions.
Model NV-T2DF
Dual FM/AM/WX Tuner
REMOTE
SENSOR
PUSH TO
ENTER
SELECT
1
6
2
7
3
8
4
9
5
0
<
<
DISPLAY MEMORY MENU PRE/DIR SOURCE ON-OFF
CATEGORY PRESET/DIRECT
Tuner B Tuner A
STANDBY
1
6
2
7
3
8
4
9
5
0
<
<
DISPLAY MEMORY MENU PRE/DIR SOURCE ON-OFF
CATEGORY PRESET/DIRECT
PUSH TO
ENTER
SELECT
FM 94.1
Classic Rock AM 550 Stereo
FM STEREO•AM•WEATHER FM STEREO•AM•WEATHER
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15
- –- –
---
---––– –- - –- –
---
---––– –-
Page 6