Raymarine 320 - Manual (Page 80)

Chapter 3: Operation 3-51
Figure 3-56: Name Track Soft Keys
4. To name the route press the YES soft key.
i. Use the trackpad left/right to select the character you wish to edit
and the trackpad top/bottom to change the character.
ii. Press ENTER to finish and clear the Track List.
5. To save the unnamed track, press the NO soft key to clear the list. The
track is saved and is listed as TRACK NOT NAMED.
6. Press ENTER to finish and clear the Track List.
7. To return to the Track soft key display, press CLEAR.
8. To return to the default soft key display, press CLEAR again.
Naming, Erasing and Showing a Track
➤
To name an existing track, erase a track or show a track:
1. Press the TRACK LIST soft key; the Track List is displayed.
The highlight indicates the selected track.
2. Using the trackpad top/bottom, select the required track and press the
SAVE TRACK, NAME TRACK or ERASE TRACK soft key.
3. To NAME a track, use the trackpad left/right to select the character you
wish to edit and the trackpad top/bottom to change the character.
4. Press ENTER to finish the operation or CLEAR to cancel the name.
5. To ERASE a track you are prompted to confirm:
i. Press NO to cancel the operation, then ENTER if you wish to
remove the Track List.
ii. Press YES to erase the track from the Track List, then ENTER to
remove the Track List.
6. If you select SHOW a track when a current, unsaved track is displayed,
you are prompted to save the current track. Proceed as described in
Clearing the Current Track on page 3-49 or press the NO soft key to
cancel the operation.
The Track List is removed and the selected track is displayed.
YES NO
NAME TRACK?
D4922-1
81167_3.BOOK Page 51 Wednesday, November 21, 2001 2:12 PM