Roberts Radio CD9949 - Manual (Page 5)

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri) 4
Operating the radio
1. Slide Function switch to the Radio position.
2. Slide Waveband switch to select the required wave band . For the
FM waveband fully extend the Telescopic aerial angle and rotate,
if necessary, to obtain best reception.
3. Press and hold down either the Tuning up or Tuning down buttons
for more than 0.5 sec to commence scan tuning. An audible tone will
be heard indicating that the radio is tuning. The tone will increase in
pitch for tuning up and decrease in pitch for tuning down.
4. Your radio will scan the selected waveband, sound a beep tone and
stop automatically when it finds a station of sufficient strength.
5. To recommence scan tuning, press and hold down either the
Tuning up or Tuning down buttons for more than 0.5 sec.
6. When the waveband end is reached the radio will beep and continue
tuning from the opposite waveband end.
7. Adjust the Volume and Tone controls to the desired settings.
8. To switch off your radio slide the Function switch to the Off/Tape
position.
Note: On FM if a station being received is weak some hiss
may be audible. To reduce the hiss slide the FM Stereo/Mono
switch (on rear) to the mono position. The stereo indicator
will be removed from the display.
Radio Tape
Off
CD
FM MW LW
TUNING
VOLUME
Min Max
Tone
Min Max
1 2
3
3
7 7
cd9949 instruction book.PMD 8/31/2005, 3:17 PM 5