RocketFish RF-RBKIT - Manual

QUICK SETUP GUIDE
QUICK SETUP GUIDE
SPEAKER-OUT (4-8 Ohm)
09-0476
Step 3 Establishing communication
To power on and switch to joining mode:
1 Press and hold the button on the hub unit (the hub will be identified by a solid green power LED or flashing green if there
are no other devices connected to the network) for more than three seconds to put the unit into joining mode.
The unit will stay in joining mode for about 30 seconds.
• The Power/Join indicator starts blinking fast.
2 Press and hold the button on the Rocketfish receiver for more than 3 seconds to put the unit into joining mode.
The unit will stay in joining mode for 30 seconds.
The Power/Join indicator starts blinking quickly. When connected, both units will show a solid LED for successful connection.
• If the Power/Join indicator blinks at a slower rate, the link is not successful. Retry the joining operation.
See your User Guide for additional information.
SPEAKER-OUT (4-8 Ohm)
R L
120V~,60Hz
AC IN
Step 2 Connecting the receiver
Connect the right surround
speaker to the right speaker
terminal of the receiver, using
the supplied three-foot speaker
cable. Connect the red
speaker cord to the red (+)
terminals, and the black speaker
cord to the black (-) terminals.
Repeat to connect the left
speaker.
TM
Please read before setting up your system.
Every Rocketboost network must contain at least one hub device, which directs network data traffic and helps devices
join the network. The network can have only one hub, which can be enabled by using the hub switch on the back of all
Rocketboost transmitters. See your User Guide for instructions on joining devices to the network.
Step 1 Preparing the remote control
To activate the battery:
Remove the tab from the bottom of the remote control to enable the battery.
TM
9 10
R L
120V~,60Hz
AC IN
11
1 Standby LED
2 Power/Join button
3 Power/Join indicator
4 Bass button
5 BASS indicator
6 SOURCE indicator
7 SOURCE button
8 HD indicator
9 IR sensor
10 VOLUME knob
Receiver
1 2 3
12 13 14
11 Removable cable spool slot
12 AC IN connector
13 Removable cable spool slot
14 SPEAKER OUT jacks
5 4 8 7 6
SPEAKER-OUT (4-8 Ohm)
Package contents:
Wireless receiver
IR remote
AC cable
User Guide Cable spool
3 ft. speaker cable (2)
Quick Setup
QUICK S
ETUP GUIDE