RCA Scenium L50000 - Manual (Page 76)

Chapter 4 Basic Operation Chapter 4 Basic Operation
72
Changing Between DIRECTV and TV Mode
When you press the number buttons on your remote control to change channels,
your TV tunes to programming from one of 4 sources:
• the DIRECTV satellite (if you have DIRECTV service) — DIRECTV mode
• a terrestrial off-air antenna — TV mode
• cable TV — TV mode
• video input channel (external components connected to the TV’s Input Jacks)
— TV mode (explained on page 74)
You tune to one of these sources by pressing either TV or DIRECTV on the remote
control; then you can enter the channel numbers (explained in detail on the next
page).
In TV mode, you tune to channels that carry the terrestrial off-air or cable TV
signal.
• To tune to an analog channel, enter channel numbers that are up to three digits
long. Press OK to tune.
• To tune to a digital channel, enter channel numbers that are one, two, or three
digits long. If necessary, press the right arrow and enter a subchannel number.
These subchannel numbers appear in the box to the right of the primary
channel number. Press OK to tune.
DIRECTV
VCR 1
VCR 2
ON•OFF TV
DVD
AUX AUD
M1
L1
M2
L2
M3
L3
FRONT
SKIP MUTE
CH +
VOL + VOL -
CH - CENTER REAR
GO
BACK FORMAT
TEST
GUIDE INFO
AM•FM
OK LEVEL + LEVEL -
MENU
PROGRAM
CLEAR
Primary
Channel Subchannel (if
necessary)
Right arrow button
DIRECTV
VCR
1 VCR 2
ON•OFF TV
DVD
AUX AUD
M1
L1
M2
L2
M3
L3
FRONT
SKIP MUTE
CH +
VOL + VOL -
CH - CENTER REAR
GO BACK FORMAT
TEST
GUIDE INFO
AM•FM
OK LEVEL + LEVEL -
MENU
PROGRAM
CLEAR
OK button
TV mode channel entry
DIRECTV mode channel entry
In DIRECTV mode, you tune to channels that come from the DIRECTV satellite
signal (if you subscribe to DIRECTV
® programming). Enter the channel numbers (1
to 4 digits long) and press OK (explained in more detail on the next page).