Razor Jr - Manual (Page 3)

TOOLS REQUIRED FOR PROPER ASSEMBLY
13mm box wrench or adjustable wrench
1. Assembly Instructions
WARNING: Failure to properly install and tighten the handlebar T-
tube and front fork clamp may cause the rider to lose control and fall.
Assembly must be performed by an adult with mechanical experience. If you
do not understand these instructions or the concept of “tighten securely” seek
the assistance of a qualified mechanic.
ASSEMBLY INSTRUCTIONS:
A. Slide metal washer (B) over the fork tube (A). Slide the fork tube into the
steering column (G) until the metal washer seats against the preinstalled
plastic steering bushing (C).
B. With the front wheel pointed straight ahead (and the slot in the fork facing
the scooter), slide the clamp assembly (E) onto the fork tube. Align the
open end of the clamp with the slot in the fork as shown in H.
C. Slide the plastic clamp cover (F) up the T-tube and insert the T-tube into
the fork tube until the “max. insertion mark on the handlebar assembly is
no longer visible. Align the T-tube square to the front wheel.
D. Secure the handlebars by tightening the clamp nut using a 13mm wrench
Tighten securely, but note that the nut is designed to prevent over-
tightening. Slide the plastic cap down over the clamp bracket to prevent
injury.
E. Place the foam for handlebar pad onto handlebar and wrap and secure
the the cover with the velcro strips.
2. Razor Jr. Safety Tips
A. Kids under 8 year of age shouldn’t ride the RAZOR Jr. without adult
supervision. The Razor Jr. is not recommended for children under the age
of 3.
4 5
A
B
C
D E
G
F
B
H