Rockford Fosgate PSD-1 - Manual (Page 18)

– 14 –
T
R O U B L E S H O O T I N G
Symptom Diagnosis Remedy
PSD does not
turn on (Remote
Disabled)
TROUBLE- S
H
O
O
T
I
N
G
Remote Turn-On wire
must be used with a
250m
2 , 500m or 250m
Data Interface Cable
between amplifier and
PSD is damaged
Amplifier is not work-
ing properly
Voltage applied to the
PSD Remote Turn-On
wire is not between 8
and 15.5 or there is no
voltage present
Optional switch (if used)
is damaged or in the
“OFF” position
Data Interface Cable
between amplifier and
PSD is damaged
Amplifier is not work-
ing properly
R
OCKFORD
F
OSGATE
A
CCESSORIES
PSD C
ABLES
(CC-1188)
20 foot 8-conductor cables are available separately for the connection
of an additional mono amplifier to Punch Status Display. This will allow
the PSD to accommodate a pair of Mono amplifiers operating individu-
ally or a pair of Mono amplifiers bridged.
Enable Remote jumper and
connect Remote Turn-On
(blue wire) to a source of
switched +12V
Check connections, substitute
with known working cable
and repair or replace as nec-
essary
Check connections, substitute
with known working ampli-
fier and repair or replace as
necessary
Check wiring and repair if
necessary. If voltage is above
15.5 volts, have the electrical
system inspected by an au-
thorized car service center
Bypass switch – if PSD turns
on, check connections and
switch position and repair or
replace as necessary
Check connections, substitute
with known working cable and
repair or replace as necessary
Check connections, substitute
with known working ampli-
fier and repair or replace as
necessary
PSD does not
turn on (Remote
Enabled)