Subaru Robin Power Products Robin Pump PTX201D - Manual (Page 15)

10
ENGLISH
FRANÇAISE
ESPAÑOL
1. FUNCTION OF OIL SENSOR
The engine will stop automatically when the oil
level falls below the safety limit. The engine
cannot be started unless the level is raised above
the prescribed limit.
(See Fig. 2-t)
In a dry or wooded area, it is recommendable to
use the product with a spark arrester. Some
areas require the use of a spark arrester. Please
check your local laws and regulations before
operating your product.
The spark arrester must be cleaned regularly to
keep it functioning as designed. A clogged spark
arrester:
Clean the spark arrester screen
Use a brush to remove carbon deposits from the
spark arrester screen. Be careful to avoid
damaging the screen.
The spark arrester must be free of breaks and
holes. Replace the spark arrester if it is damaged.
Install the spark arrester, and muffler protector in
the reverse order of disassembly.
How to remove the spark arrester
1. Remove the flange bolts from the muffler cover
and remove the muffler cover.
2. Remove the special screw from the spark
arrester and remove the spark arrester from
the muffler.
If the engine has been running, the muffler and
the spark arrester will be very hot. Allow the
muffler to cool before cleaning the spark arrester.
Prevents the flow of exhaust gas
Reduces engine output
Increases fuel consumption
Makes starting difficult
2. RESTARTING
(1) Fill the crankcase with oil up to the proper
level.
(2) As for restarting and operating the engine,
refer to section “OPERATING YOUR PUMP”
on page 6.
Check the wire connector from the engine. It
must be connected securely to the wire from oil
sensor.
When selecting the engine oil, refer to page 5
for the recommended oil.
OIL SENSOR INSTRUCTIONS
SPARK ARRESTER
SPARK
ARRESTER
SCREEN
SCREW
DEFLECTOR
MUFFLER
MUFFLER COVER
SPARK ARESSTER SCREEN