ReliOn RCM-832N - Manual (Page 4)

SET UP
NOTE: WE RECOMMEND THAT THE HUMIDIFIER BE DISINFECTED PRIOR TO FIRST USE.
PLEASE SEE CLEANING INSTRUCTIONS.
• Select a firm, level, flat location - at least six inches (15 cm) from any wall for proper
air flow (Fig. 1). Place the humidifier on a water-resistant surface, as water can dam-
age furniture and some flooring.
The manufacturer will not accept responsibility for property damage caused by water
spillage.
• Remove the water tank by grasping handle and pulling
straight up. Set aside (Fig. 1).
• Remove the Filter from the base before filling the unit with
water (Fig. 2). Soak filter in a sink full of cool water to help
reduce mineral build up and place back in the humidifier
while wet. DO NOT SQUEEZE OR WRING OUT THE FILTER.
To help extend the life of your filter repeat this step each
time you fill your humidifier.
• Turn the Water Tank upside down so that the Fill Cap is fac-
ing up; unscrew the Fill Cap by turning it counter-clockwise
and set aside.
• Fill the Water Tank with COOL tap water (Fig. 3). Distilled
water is not necessary as the water is filtered by the Filter.
DO NOT USE HOT WATER. Doing so may damage the humid-
ifier.
• Replace the fill cap by turning it clockwise . DO NOT
OVER TIGHTEN. Turn the Water Tank right-side up.
NOTE: WHEN CARRYING THE FILLED WATER TANK PLEASE
USE THE HANDLE AND PLACE YOUR OTHER HAND UNDER
THE TANK FOR ADDITIONAL SUPPORT.
FILLING
HANDLE Fig. 1
Fig. 2
Fig. 3
RCM-832N OM_Rev1.qxd 6/22/06 10:35 AM Page 4