Razor MX500 15128190 - Manual (Page 7)

6
REPAIR AND MAINTENANCE
q Chain and Rear Tire Replacement – MX350
Tools required: 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches.
2 With a 10mm wrench,
loosen the brake cable anchor
and disconnect the cable.
3
With two 8mm wrenches,
loosen brake housing anchor
and disconnect. Keep the spacer
and washers together.
4 With two 17mm wrenches,
loosen the axle. Push the chain
tensioner down to loosen the
chain and pull the wheel out.
Note: Your hands will get greasy
doing this.
5 Pull the wheel out. Note the
arrangement of the hardware
sequence.
6 Install the new chain or
wheel by slipping the chain
around the axle. Slide the axle
into the slots on the frame.
Slide the chain tensioner down
and maneuver the chain onto
the rear sprocket and front
sprocket.
7 To hook up the brake housing
anchor, align the cable guide
adjuster and install the spacer
and bolt. Do not tighten until
final step.
8
Install the brake spring and
thread the cable wire into the
cable anchor. Thread the cable
to its original position and
tighten securely.
9
Tighten the brake housing
anchor securely. Re-attach
the chain guard. Test ride and
check. Readjust as needed.
1
Loosen screws and remove
chain guard.