Renesas M3A-HS37 - Manual (Page 38)

Operational Specifications
3.1.6 Expansion Connectors (J8 to J12)
Rev.1.00 Oct 09, 2008 3-8
REJ11J0021-0100
3
3.1.6 Expansion Connectors (J8 to J12)
The M3A-HS37 is provided with through-holes for expansion connectors. The SH7137 I/O pins are connected to the
through-holes.
MIL-spec connectors can be connected to the through-holes (J8 to J12), allowing for connecting with expansion boards or
monitoring the SH7137 bus signals. Figure 3.1.7 shows the pin assignments for expansionsion connectors.
Board edge
19 20
1 2
J10
40
39
2
1
20
19
2
1
Top view of the
solder side
J12
J11
40
39
2
1
20
19
2
1
J9
J8
Board edge
19 20
1 2
J10
40
39
2
1
20
19
2
1
J12
J11
40
39
2
1
20
19
2
1
J9
J8
Top view of the
component side
Board edge
Board edge
Note： These pin assignments on the CPU board are defined on the assumption that
expansion connectors are mounted on the component side. If the expansion connectors are
mounted on the solder side, these pin assignments are not applicable.
Figure 3.1.7 Pin Assignments for Expansion Connectors