Ryobi RJ150V-02 - Manual (Page 10)

Page 10
Standard universal 1/2 inch shank reciprocating saw blades
available at your local supplier may be used with your Ryobi
reciprocating saw.
GENERAL
Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to various types of commercial solvents and
may be damaged by their use. Use clean cloths to remove
dirt, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
It has been found that electric tools are subject to accelerated
wear and possible premature failure when they are used on
fiberglass boats, sports cars, wallboard, spackling compounds,
or plaster. The chips and grindings from these materials are
highly abrasive to electric tool parts such as bearings, brushes,
commutators, etc. Consequently, it is not recommended that
this tool be used for extended work on any fiberglass material,
wallboard, spackling compounds, or plaster. During any use
on these materials, it is extremely important that the tool is
cleaned frequently by blowing with an air jet.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing dust.
If operation is dusty, also wear a dust mask.
WARNING:
When servicing use only identical Ryobi replacement parts. Use of any other parts may create a
hazard or cause product damage.
ACCESSORIES
MAINTENANCE