Roberts Radio Gemini 59 RD-59 User Manual
Page 13
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
12
Operating your radio - FM
1. Carefully extend the telescopic aerial.
2. Press
the
On/Off button to switch on your radio. The display will show
"ROBERTS" for a few seconds.
3. Press
the
Band button to select the FM band.
4. Press and release the Select button until the display shows
"Auto tune <>".
5. Press
the
Tuning Up button. Your radio will scan from the currently
displayed frequency direction upwards and will stop scanning when
it fi nds a station of suffi cient strength.
6. The display will show the frequency of the signal which has been
found. If RDS information is available, after a few seconds the display
will show the radio station name. The display will also show "St" and
"RDS" on the upper line if the station is received with stereo and RDS
information.
7. Press
the
Tuning Down button to scan the FM band in a downwards
direction (high frequency to low frequency).
8. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
9. Adjust
the
Volume control to the required setting.
10. To switch off your radio press the On/Off button.
3
2
5
4
7