Rangemaster RDW6015FI - Manual (Page 12)

10
½ Load Button
This function allows the dishwasher to wash dishes using only
the upper rack if there are not enough dishes for a full load.
This will allow you to save on water and energy consumption.
To select ½ load:
1.
Select the programme and then press the ½ load button
(Fig.2-19) – the ½ load indicator blinks.
2. Close the door. The programme starts automatically.
To cancel the ½ load
Follow the ‘Cancelling a programme in progress’ instructions.
Note: Please keep in mind that the amount of detergent
should also be adapted to the ½ load.
3-in-1 Function
When using ‘3-in-1’ dishwasher tablets the rinse aid and salt
functions are no longer useful. It may be advisable to switch
the rinse aid off and select the lowest possible setting for
water hardness.
Press the ‘3-in-1’ button (Fig.2-20) to deselect the rinse aid
function.
If returning to a standard detergent system it is advisable to:
1. Refill both the salt and rinse aid compartments.
2. Switch the water hardness setting to the highest
possible position and run for three normal cycles
without a load.
3. Readjust the water hardness setting again for local
water conditions.
Memory Function Module
If a power cut occurs while the selected washing program
is active, the program is not cancelled. The controls use a
microprocessor device to memorize the information about
the selected washing program. Once the power is returned
to the machine, the dishwasher will resume from the point it
was interrupted.
ArtNo.800-221
- RDW6015
- 1/2 load
Fig.2-19
ArtNo.800-223
- RDW6015 - 3-in-1
Fig.2-20