Remington M12510US - Manual (Page 9)

9 113005 www.desatech.com
ENGLISH
OPERATING CHAIN SAW
WARNING: Read and understand this
owner’s manual before operating this saw.
Make certain you read and understand all
Important Safety Information, pages 3
through 5. Improper use of this chain saw
can cause severe injury or death from
fire, electrical shock, or body contact with
moving chain, or falling wood.
Continued
T
I
G
H
T EN
Approx.
1/8"
TIGHTEN
Turn chain tensioning screw
clockwise to tension saw chain...
❸
SAW CHAIN TENSION
ADJUSTMENT
Continued
Pull chain to check tension. Guide
links should not come out of guide
bar groove...
❹
Make sure chain moves freely around
guide bar then tighten nut.
❺
FILLING OIL TANK
1. Remove oil cap.
2. Fill oil tank with SAE #30 motor oil.
Note: For
temperatures below 30°F, use SAE #10 oil. For
temperatures above 75°F, use SAE #40 oil.
3. Replace oil cap at once. Tighten oil cap firmly for
good seal. This will avoid oil seepage from tank.
4. Wipe off excess oil.
Note: It is normal for oil to seep when saw is not in use.
Empty oil tank after each use to prevent seepage.
OILING CHAIN
Manual Oil System
Always check oil level before using saw. Do not
attempt to operate the oil system while saw is in
operation. To oil chain, press squeeze bulb. Oil will
feed onto the guide bar and chain. Press squeeze
bulb at least once before each cut. Check oil level
often by looking at oil level through side of oil bottle
(see Figure 9).
Guide Bar
Figure 9 - Oil Squeeze Bulb and Oil Bottle
Location
Oil Bottle
Oil Squeeze Bulb