ResMed Humidifier User Manual

Page 11

Advertising
background image

6

Notes

To replace the front cap, align it with your flow generator (B-4) and push it firmly until it
clicks into place.

Remember to take the front cap with you when travelling, in case you need CPAP
therapy without a humidifier.

R

EMOVING

AND

STORING

THE

CONNECTOR

PLUG

Please refer to the illustrations in section C of the illustration sheet.
Before attaching the H

UMID

A

IRE

3i, remove the connector plug from your flow

generator (C-1) and attach it to the back of the docking station (C-2).

A

TTACHING

YOUR

H

UMID

A

IRE

3i

Please refer to the illustrations in section D of the illustration sheet.

1

Align your H

UMID

A

IRE

3i with your flow generator (D-1) and push them together

until they click into place (D-2).

!

WARNING

The HumidAire 3i docking station should only be connected or disconnected
when the water chamber is empty.

Water must be prevented from entering your flow generator. Do not transport
the flow generator with the HumidAire 3i attached.

2

Insert the power cord into the socket at the rear of your flow generator. Plug the other
end of the power cord into a power outlet (D-3).

Note: If your flow generator is powered via the DC input, the HumidAire 3i is not powered
and humidification output will be reduced.

3

Place the combined unit on a firm, level surface near your bed at a level lower than
your sleeping position. Ensure the surface is not sensitive to heat and/or moisture, or
use a protective mat.

!

CAUTION

Be careful not to place the unit where it can be bumped into and knocked over.

4

Connect one end of the air tubing firmly onto the air outlet of your H

UMID

A

IRE

3i

and the other end to your mask (D-4).

F

ILLING

THE

WATER

CHAMBER

Please refer to the illustrations in section E of the illustration sheet.

!

WARNING

Take care when handling your HumidAire 3i. The water and the water chamber
base may both be hot. Allow ten minutes for the heater plate and any excess water
to cool.

1

Release the cover latch (E-1) and lift the cover until it rests in the upright position (E-2).

33804r2.book Page 6 Wednesday, May 25, 2005 2:54 PM

Advertising