RCA DVR10 - Manual (Page 6)

Overview & Setup
4 Chapter 1 Illustrations contained in this document are for representation only.
Overview & Setup
Chapter 1 5 Illustrations contained in this document are for representation only.
DVR10 Back
The back of the DVR10 has two 6-pin DTVLink® or IEEE 1394 ports and an A/C power cord
connector. Devices using IEEE 1394 interface can be connected to either port. Devices certified as
DTVLink use the same IEEE 1394 interface but also include advanced copy protection schemes to
send and receive encrypted or copy protected content.
Things to Consider Before You Connect
Ensure Proper Ventilation of the DVR10:
• Leave at least 4 inches (10 cm) of space between the top and back of the DVR10 and a wall,
shelf, or other component.
• Leave at least 1” (2.5 cm) of space on the front and sides.
• Do not block ventilation holes on any of the components.
• Arrange the components so that air can circulate freely.
• Do not stack components on top of the DVR10.
• When you place components in a stand, make sure you allow adequate ventilation.
• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from
it won’t flow around other components.
1394 Ports AC Power Cord Connector
DVR10 Top View
DVR10 Front View
DTVLink® Cetification Logo is a U.S. registered mark of CEA.