Replacing the battery – Rolodex RF-48A User Manual

Page 27

Advertising
background image

26

This organizer uses one CR2032, 3-volt lithium battery.
Before you follow these steps you should have a small
Phillips screwdriver and the new battery at hand.
Warning! When no battery is installed, this organizer will
save your information for only about 30 seconds. So
quickly install the new battery when you remove the old
one.
1. Turn the organizer off and turn it over.
2. With the Phillips screwdriver, remove the screw to

the battery cover and then remove the lid.
Do not remove the screws at the sides of the
organizer.

3. Remove the old battery and quickly replace it with

the new battery, with the positive (+) sides facing
up.

4. Replace the battery cover.

Warning! If

RESET? appears when you next turn on

the organizer, do not press ENTER unless you want
to reset the organizer and erase all your information.

Keep Written Copies of Important Data

This organizer stores your information as long as the
battery supplies power.

Warning! If the battery loses power or is removed, all
your information will be lost. Information can also be
lost or corrupted if you make a mistake while operating
this organizer. Therefore, always keep written copies
of your important information in case it is corrupted or
lost.

Replacing the Battery

Advertising
This manual is related to the following products: