Roland pt-2000 - Manual (Page 21)

21
Connecting to Audio Equipment
When you connect the pt-2000 to audio equipment, you can
play the sounds from the pt-2000 through the speakers on the
audio equipment or record your performances on a tape
recorder or other recording device.
■ Connectors
fig.09-10
Output Jacks
You can connect audio equipment using audio cables (sold
separately) and play the sounds from the pt-2000 through the
speakers on the connected equipment or record your
performances on a tape recorder or other recording device.
If the output of the connected device is monaural, you must
use the L (Mono) jack.
Input Jacks
You can connect another sound source, such as audio
equipment or an electronic instrument using audio cables
(sold separately) and play the sounds from the connected
device through the speakers on the pt-2000.
If the output of the connected device is monaural, you must
use the L (Mono) jack.
■ Making the Connections
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
* Always make sure to have the volume level turned down before
switching on power. Even with the volume all the way down,
you may still hear some sound when the power is switched on,
but this is normal, and does not indicate a malfunction.
❍ Playing Sounds from the pt-2000 Through the
Speakers on Audio Equipment or Recording
Your Performances on a Recording Device
fig.59
1. Turn the volume all the way down on the pt-
2000 and on the device you’re about to
connect.
2. Turn off the power to the pt-2000 and other
connected equipment.
3. Use audio cables (sold separately) to make
the connection.
4. Turn on the power of the pt-2000.
5. Switch on the connected device.
6. Adjust the volume level on the pt-2000 and
the connected device.
When Recording pt-2000 Performances on a Recording
Device
7. Start recording with the connected device.
8. Play the keyboard.
9. When the performance ends, stop
recording on the connected equipment.
❍ Playing Audio Equipment Sounds Through the
Speakers on the pt-2000
fig.60
1. Turn the volume all the way down on the pt-
2000 and on the device you’re about to
connect.
2. Turn off the power to the pt-2000 and other
connected equipment.
3. Use audio cables (sold separately) to make
the connection.
4. Turn on the power to the connected
equipment.
5. Turn on the pt-2000.
6. Adjust the volume level on the pt-2000 and
the connected device.
❍ Turning the Power Off After Use
After use, follow the steps below to switch off the power.
1. Turn the volume all the way down on the pt-
2000 and on the device you’re about to
connect.
2. Turn off the power to the pt-2000.
3. Turn off the connected equipment.
Output
R L(Mono)
Input
R L(Mono)
Stereo Stereo
pt-2000
Input R/L
(Line In, Aux In)
In Out
Pedal MIDI
Output
R L(Mono)
Input
R L(Mono)
Stereo Stereo
Output R/L
(Line Out, Aux Out)
pt-2000
In Out
Pedal MIDI
Output
R L(Mono)
Input
R L(Mono)
Stereo Stereo