Roksan Audio MkIII - Manual (Page 6)

Roksan Audio ltd Kandy Integrated Amplifier User Manual
CLASSIFICATION: General Use Version 3.0
All specifications are liable to change without notice. E&OE Page 6 of 11 ENGLISH
Carefully remove any overal sheath or split the figure 8 cable to a depth of about 75mm (3”).
Carefully strip the insulation on each wire to a depth of about 12mm (1/2”) exposing the
bare core. If the conductor is stranded, twist the strands together on each conductor.
Unscrew the binding post. There is a cross-hole about 5mm from the panel end of the
binding post. Insert the bared conductor through the hole and tighten the binding post
securely making sure that there are no loose strands or bare ends protruding through
the post.
Carefully observe polarity ensuring that the RED (+) speaker terminal is connected to
the RED (+) amplifier terminal and the BLACK (-) speaker terminal to the BLACK (-)
amplifier terminal.
When both left and right channels are connected to their respective speakers the
amplifier is ready for use.
IMPORTANT NOTE: For optimum performance it is recommended to use high quality cables such as ROKSAN
HDC-01S High Definition Loudspeaker Cable. Many speaker cables such as the ROKSAN HDC-01S are
directional. Please observe this directionality. DO NOT use a speaker cable with conductor size less than 16
AWG (1.6mm Diameter). The Binding posts accept conductor sizes up to 12 AWG.
Multi-Amping The Loudspeakers
Setup
If the Loudspeakers utilise more than one drive unit with individual input terminals, for example a Tweeter and a
Woofer, then the loudspeaker performance will benefit from Bi-Amping. Dedicating one amplifier to the Tweeter
and another to the Woofer isolates them from each other hence reducing distortion and increasing reserved
power. Speakers work far better with most amplifiers when Multi-Amped than using one yet more powerful
amplifier.
For setup and connection details on Multi-Amping refer to the Kandy Power Amplifier Manual.
Note: Multi-Wiring connects the Woofer and the Tweeter directly to the output of the amplifier and is the first step
towards Multi-Amping.
MULTI-WIRING THE LOUDSPEAKERS
Tri-wired Speaker Bi-wired Speaker
IMPORTANT!
Speaker Drive Unit
Links must be removed