Rangemaster DELUXE U109360 - 01 - Manual (Page 31)

31
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
20 To Remove an Oven element Thermal Cut-Out.
Disconnect from the electricity supply.
Pull the cooker forward to gain access to the cover
box. Undo the cover screws and lift clear. The cutout
is located on the earth plate beside the oven element
connections. Disconnect the cutout wiring. Undo the
fixings that secure the cutout to the earth plate and
remove. Fit replacement control and re-assemble in
reverse order.
21. To Remove Oven Element.
Disconnect from electricity supply.
Remove oven inner back (see 18).
Remove 2 screws from the
top of the element and 1 from
the bottom of the element
in side the oven. Lift element
out carefully, disconnect the
terminals connected to the
element noting their positions.
If it is not possible to disconnect
the leads in this way, pull cooker
forward to gain access to the
rear.
Remove screws securing the electric cover to the back
sheet and remove cover and disconnect the terminals
from the rear.
Fit new element, and reassemble in reverse order. Check
operation of oven.
22. To change oven light bulb.
LH Oven
Remove the oven furniture and side linings. Remove the
oven rear liner.
RH Oven
Remove the oven inner back (see 18). The oven light
cover is now accessible. Unscrew the cover.
Unscrew the bulb.
Fit an Edison screw fitting 15w 240v lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300°C.
Check correct door operation.
17. To Remove Grill Element.
Disconnect from electricity supply.
Remove grill pan from grill chamber. From inside grill
compartment remove enamelled front shield from
grill roof, 2 screws and washers. Remove 2 screws
and washers securing the grill element front support.
Remove the screws from the grill elements.
Lift elements out carefully, disconnect the leads from
the element terminals noting their position. If it is not
possible to disconnect the leads in this way, pull cooker
forward to gain access to the rear, remove screws
securing the electric cover to the back sheet and remove
cover and disconnect the terminals from the rear.
Fit new elements, reassemble in reverse order. Check
operation of grill.
18. To Remove an Oven Inner Back.
Open the oven door and remove the screws and washers
securing the inner back to the back of the oven.
Carefully lift away the inner back. Reassemble in reverse
order making sure that the 4 screws and washers are
fully tightened.
19. To Change Fan in Oven.
Disconnect from electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Disconnect the 3 terminals connected to
the fan noting their position. Remove oven inner back
(see 18). Hold the fan blade and remove the centre nut
(left hand thread) 2 brass washers, fan blade and Circlip.
Unscrew fan retaining nuts and washers (3 off each) and
lift the fan away from the rear of the cooker. Fit new fan
and reassemble in reverse order. Check operation of
oven.