Ryobi P510 - Manual (Page 12)

12
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the battery
pack will become hot. You should let a hot battery pack cool
down for approximately 30 minutes before attempting to
recharge. When the battery pack becomes discharged and
is hot, this will cause the green LED to come on instead of
the red LED. After 30 minutes, reinsert the battery pack in
the charger. If the green LED continues to remain on, return
battery pack to your nearest Ryobi Authorized Service Center
for checking or replacing.
NOTE: This situation only occurs when continuous use of
the tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to “CHARGING
A COOL BATTERY PACK” for normal recharging of batter-
ies. If the charger does not charge your battery pack under
normal circumstances, return both the battery pack and
charger to your nearest Ryobi Authorized Service Center
for electrical check.
TO REMOVE / ATTACH BATTERY PACK
See Figure 5.
To remove:
n
Locate latches on side of battery pack and depress both
sides to release battery pack from your saw.
n Remove battery pack from your saw.
To attach:
n
Place the battery pack in your saw aligning raised rib on
battery pack with groove in saw's battery port.
n Make sure the latches on each side of the battery pack
snap into place and battery pack is secured to saw before
beginning operation.
OPERATION
Fig. 3
P110
CHARGER
GREEN LED
YELLOW LED
RED LED
Fig. 4
BATTERY
PACK
P110
CHARGER
BATTERY PACK SHOWN ATTACHED TO CHARGER
Fig. 5
BATTERY
PACK
DEPRESS LATCHES
TO RELEASE
BATTERY PACK
BATTERY PORT
LATCH