Rockford Fosgate P162S - Manual (Page 6)

6
I
NSTALLATION
-T
WEETERS
I
NSTALLATION
-S
PEAKERS
Wiring Tweeter to Crossover
1. Use illustrations for proper connection.
2. Be sure to maintain speaker polarity
Use this section when installing Systems
1. Cut the proper size hole for the speaker.
NOTE
: See Specifications for proper hole size.
2. Place the mounting ring over the mounting hole and mark the location of the screw mounting holes.
3. Remove the ring. Drill the holes for the screws using a 1/8" drill bit.
4. Route the wire through the mounting hole cut-out.
5. Attach the wires. Observe proper speaker polarity.
6. Place the mounting ring over the speaker.
7. Place the speaker into the hole and screw the speaker into place.
One Channel
from Source
or Amplifier
One Channel
from Source
or Amplifier
Use this when installing Systems
Use this when installing
Tweeter Kit