Razor POCKET ROCKET 155001 - Manual (Page 5)

1
To adjust the play, thread
the brake lever adjuster in or
out 1/4 to 1/2 turn until the
desired brake adjustment is
attained. Most adjustments are
complete at this step. If brake
still needs further adjustment,
proceed to step 2.
2
If the brake lever adjuster is
threaded outward and the brake
still has too much slack, use the
back brake adjuster at the rear
brake for additional adjustment.
warning:
The brake is capable of
causing the electric motorbike
to skid the tire throwing an
unsuspecting rider. Practice
in an open area free from
obstacles until you are familiar
with the brake function. Avoid
skidding to a stop as this can
cause you to lose control or
damage the rear tire.
repair and Maintenance
Check the Razor web site for any updates on the latest repair and maintenance procedures.
Turn power switch off before conducting any maintenance procedures.
q adjusting the Brake
inflating the tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of
manufacturing and your purchase.
Front Tire Rear Tire
Note: The pressurized air
supplies found at gasoline
stations are designed to inflate
high-volume automobile tires.
If you decide to use such an
air supply to inflate your tires,
first make sure the pressure
gauge is working, then use very
short bursts to inflate to the
correct PSI. If you inadvertently
over-inflate the tire, release the
excess pressure immediately.
1 Remove valve extender/
adapter from right handgrip.
testing the Brake
To use the brake, squeeze the lever to increase the pressure on the brake. The brake lever is fitted
with a cable adjuster to compensate for cable stretch and/or to fine-tune the lever movement to brake
engagement. If brake is not engaging properly, follow instructions for adjusting the brake outlined below.
asseMBly and set-up
2 To inflate the rear tire align
the access hole in the drive
sprocket with the tire valve.
Thread the adapter completely
onto the valve and attach the
pump and inflate to the psi
indicated on the tire sidewall.
1 Using a bicycle-style tire
pump equipped for a Schrader-
type valve, inflate the front
tire to the PSI indicated on the
sidewall of the tire.
4
warning:
Do not use the Pocket Rocket
for the first time until you
have inflated the tires to the
correct PSI. Failure to do so may
damage your vehicle and void
your warranty.