Runco DIGITAL LIGHT PROCESSING VX-2000D - Manual (Page 34)

Installation
22 Runco VX-2000d Owner’s Operating Manual
PRE
L
IMINAR
Y
Vertical and Horizontal
Position
Proper placement of the projector relative to the screen will yield a rectangular,
perfectly-centered image that completely fills the screen.
Ideally, the projector should be positioned perpendicular to the screen and in such a way
that the lens center and screen center are aligned with each other, as shown in Figure 3-3.
Figure 3-3. Projector Placement
Vertical Lens Shift If it is not possible to align the projector and screen as shown in Figure 3-3, you can use
the lens shift controls to center the image on the screen. Lens shift is generally expressed
as a percentage of the screen height or width, as shown in Figure 3-4.
Figure 3-4. Vertical Lens Shift (Example Only)
➤
Height
Projection Distance
Ceiling
Ceiling Installation
Screen Height
Floor
Lens Center
Projection Distance
Floor Installation
Lens Center
x
Lens Center
x
Screen Lens Center
➤
50% Height
Lens Shift
(0.5 x H)
100% Height
Lens Shift
(1.0 x H)
Screen Center
0%
Note: This is a general example of lens shift. Lenses vary in their shift capabilities. No particular
lens or projector is used in this example.