Radio Shack 62 (16-632) - Manual (Page 18)

18
2. Repeatedly press PLAY or STOP to high-
light SET UP CHANNEL , then press
FAST-F .
3. Press FAST-F again to select the broadcast
system ( TV or CATV) .
4. Press STOP to highlight AUTO SET , then
press FAST-F .
5. Press CH s . The VCR starts scanning for
and storing active channels.
Changing the On-Screen Language
The on-screen programming language is pre-
set to English, but you can change it at any
time by following these steps.
1. Press MENU to display the main menu.
2. Repeatedly press PLAY or STOP to high-
light the fourth menu selection, then press
FAST-F . The title of the fourth menu selec-
tion differs depending on the language cur-
rently selected.
3. Press FAST-F so the desired language
appears next to the fourth item.
4. When you finish selecting the language
you want, press MENU .
Resetting the VCR’s Memory
If at any time you want to erase all settings, in-
cluding the time, local channels, and pro-
grammed events, eject any loaded tape, then
hold down
PLAY and CHANNEL s on the VCR
for about 5 seconds until it turns itself off. All
settings are cleared.
The next time you turn on the VCR, it performs
its initial setup sequence. See “Setting the On-
Screen Language/Channels/Clock” on
Page 15.
Y
Y
NEL
UE : ENGL I SH
SET : KEY
SELECT : KEY
SET UP CHANNEL
ANTENNA SYSTEM : CATV
AUTO SET
END : MENU KEY
AUTO SET
A CABLE
THEN. . .
A CABLE
YOUR
H UP KEY
G GE : ESPANOL
Espanõl
Français
OSCOPE
E
A : FRANÇAI S
Y
Y
NEL
UE : ENGL I SH
English
16-549.fm Page 18 Tuesday, July 20, 1999 5:04 PM