Rival VS110 - Manual (Page 5)

1. Unscrew the three screws from the
bottom panel.
2. Remove the bottom panel.
3. Replace the old knife blade with the
new one.
4. Close the bottom panel.
5. Use screw driver to screw tightly the
three screws.
-9-
REPLACING THE INTEGRATED ROLLS
1. The bag holder is spring-loaded. Place your
hand on one end of the holder, using your
other hand to push one end of the holder
into the other until it is no longer connected
in the slot.
2. Pull open end of holder away from BAG ROLL
CHAMBER, while simultaneously pulling the
holder out of the slot located on the opposite
end of the BAG ROLL CHAMBER.
3. Slide bags onto the holder.
4. Place one end of holder back into the slot
located within the BAG ROLL CHAMBER.
Note: Make sure bags are positioned to roll out
from the bottom of the roll rather than the top.
5. Push in open end of holder so that it retracts into the other end.
6. Align the holder with the slot on the open end.
7. Release open end of holder until it connects into the open slot.
REPLACING THE BLADE IN YOUR INTEGRATED BAG CUTTER
CLEANING THE FOOD SEALER
• Always unplug the unit before cleaning.
• Always remove from wall mounted position prior to cleaning.
• Do not immerse in water.
• Do not use abrasives to clean the unit.
• Wipe the outside of the unit with a damp cloth and soap.
• To clean the inside of the unit, wipe away any food or liquid with a
paper towel.
• Dry thoroughly before using again.
CLEANING THE REMOVABLE DRIP TRAY
The Seal-a-Meal
® Vacuum Food Sealer is equipped with a REMOVABLE
DRIP TRAY that allows you to thoroughly clean it between uses. When
storing foods such as beef or chicken, juices tend to collect on the drip
tray. Follow these simple instructions to do so:
• Lift tab on one end of the REMOVABLE DRIP TRAY to release it from
the drip tray compartment.
Note: Take care not to spill inside the drip tray compartment.
• Clean the tray with soap and warm water.
• Thoroughly dry the REMOVABLE DRIP TRAY prior to placing back into
the drip tray compartment.
• Align the center of the REMOVABLE DRIP TRAY with the vacuum port
in the center of the drip tray compartment, so that the tab is on the
right and the drip tray is beneath the NOZZLE.
• Press down on the center until it is securely fastened in the drip tray
compartment.
HINT: The REMOVABLE DRIP TRAY can be placed in the dishwasher
for thorough cleaning if desired.
CARE AND CLEANING
-8-
VS11003EM3 4/1/03 10:59 AM Page 8