RedMax RECIPROCATOR SGCZ2500S - Manual (Page 12)

■ MOUNTING ENGINE (SE1)
1. Install the engine to the driveshaft so that the
cylinder head and the stop switch may come on
the same side.
2. Using attached four bolts, secure the connection
firmly with equal force (Torque: 25in-lbs)(Torque:
2.8 N.m.).
(1) Bolt
(2) Stop switch
Never use any screws other than those specified
by the manufacturer, or the engine can get loose,
resulting in a hazardous event.
Tighten the screws gradually by turns.
■ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint
on the top of the carburetor. (SE2)
■ CONNECTING SWITCH WIRES
• Connect the switch wires between the engine
and the main unit. Pair the wires of the same
color.
■ INSTALLING HANDLE
• Mount the handle to the shaft tube and clamp it
at a location that is comfortable to you. (SE3)
(1) About 19 inches (48cm)
IMPORTANT
WARNING
5. Set up
❲ 12 ❳
SE1
SE2
SE3