RedMax G2500TS - Manual (Page 9)

5. Installing guide bar and saw chain
❲ 9 ❳
SE5
SE6
6. While holding up the tip of the bar,adjust the
chain tension by turning the tensioner screw until
the tie straps just touch the bottom side of the
bar rail. (SE5)
(1) Chain tension adjusting screw
(a) Loosen
(b) Tighten
7. Tighten the mounting nut securely with the bar
tip held up (TORQUE: 11.8~14.7 N.m./120~150
kg-cm). Then check the chain for smooth
rotation and correct tension while moving it by
hand. If necessary, readjustment. (SE6)
(1) Tighten
It is very important to maintain the proper chain
tension. Rapid wear of the guide bar or the
chain coming off easily can be caused by
improper tension. Especially when using a new
chain, take good care of it since it should
expand when first used.
WARNING