RBH Sound MC SERIES - Manual (Page 7)

Your MC Series theater loudspeaker speakers are covered by a limited
warranty against defects in materials and workmanship for a period of 5 years
from the original date of purchase. This warranty is provided by the authorized
RBH Sound dealer where the speaker was purchased. Warranty repair will
be performed only when your purchase receipt is presented as proof of
ownership and date of purchase. Defective parts will be repaired or replaced
without charge by your dealer’s store or the location designated by your
dealer authorized to service RBH Sound products. Charges for unauthorized
service and transportation cost are not reimbursable under this warranty. This
warranty becomes void if the product has been damaged by alteration, misuse
or neglect. The warrantor assumes no liability for property damage or any
other incidental or consequential damage whatsoever which may result from
the failure of this product. Any and all warranties of merchantability and fitness
implied by law are limited to the duration of this express warranty. Some states
do not allow limitations on how long an implied warranty lasts, so the above
limitations may not apply to you. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you.
Situation Probable Cause Solution
No sound from speakers. Speaker wire not
connected.
Speaker selector on
amplifier is not on.
Make sure wire is properly
connected at both the
speaker and the amplifier
observing proper polarity.
Activate proper speaker
selector on amplifier.
No sound from one
speaker.
Balance control on
receiver or preamp is
not centered.
Speaker wire not
completely connected.
Place balance control in
the center.
Check all connections at
amplifier and speakers.
Only the woofer or
midrange/tweeter are
playing.
Bi-amp clips are not
intact.
Make certain gold bi-amp
clips are in place and
tightened down.
Very little bass and/or
imaging.
Speakers are wired
out of phase.
Check entire system
for proper polarity and
make adjustments as
necessary.
Troubleshooting
Warranty