Raritan Computer CommandCenter CC-SG - Manual (Page 46)

38 C OMMAND C ENTER S ECURE G ATEWAY U SER G UIDE
Managing an iLO/RILOE Power Interface
Please refer to Power Control for Nodes for additional information on managing power interfaces.
Note: Nodes of an iLO/RILOE device are powered on/off and recycled directly. Nodes connected
to Raritan Dominion devices, such as KX and SX, are managed via outlets of a power strip that
are associated with a port of a Dominion device.
Managing Power to an IPMI Server Node
Please refer to Power Control for Nodes for additional information on managing power interfaces.
Note: The IPMI Server can be powered on/off and recycled directly.
Disconnect from a Node
You can disconnect from a node by closing the application you are using to manage the node.
Power Control for Nodes
CC-SG allows you to control power for single nodes or for node groups that have power
interfaces associated with them. You can perform power on, power off, cycle power, and graceful
shutdown functions. Graceful shutdown is not available for all nodes.
Single Node Power Control
Single node power control allows you to control power for all or selected interfaces within a
single node. For power on and power off operations, you can select the order in which interfaces
are powered on and off.
Control power for all interfaces of a single node:
1. Click the node that you want to control power for in one of the node lists in the left panel.
The Node details screen appears.
2. In the Power Control section, click On, Off, or Cycle, or Graceful Shutdown to perform the
corresponding power control operation for all interfaces associated with the node.
3. Repeat the steps in this section to perform power control for additional nodes.
Control power for selected interfaces of a single node:
1. There are two ways to access Single Node Power Control for selected interfaces:
a. Click the Power Control tab at the top of the screen, and then click Single Node Power
Control to open the Single Node Power Control screen.
b. Click the node that you want to control power for in one of the node lists in the left panel,
and then click Advanced in the Power Control section of the Node details screen for the
selected node.
2. Click the Node drop-down arrow and select the node that you want to control power for from
the list. The Available list displays all interfaces in the selected node.
3. In the Available list, select the specific interface that you want to perform power control on,
and then click Add to move the interface to the Selected list. Repeat this step until you have
added all necessary interfaces to the Selected list.
4. You must put the interfaces in the Selected list into the order in which you would like CC-SG
to perform the power operation. Select an interface in the Selected list, and then click the up
and down arrows to move the interfaces into the desired sequence.