Roland DM-5 - Manual (Page 7)

Espa
ñ
ol
Italiano
Fran
ç
ais
Deutsch
English
7
Function and Connection
Assign Switch
This switch selects the stereo position of the digital signal.
It selects Right, L+R, or Left when using two DM-5 monitors
for stereo sound (with digital signals).
Choose the setting appropriate for your setup.
* With the DM-5, there is no difference between L and R.
When using the digital input connectors of two DM-5 monitors
for stereo sound, the digital signal can be input to either L or R.
11. Power Switch
This switch turns the power on/off.
12. AC Inlet
Connect the included Power cord here. Plug it firmly in, so
that the cable does not accidentally become disconnected.
13. Power Cord
This box contains continental and British power cables.
Please select the correct type for your country.
14. Input Select Switch
Used to select Digital Input or Analog Input.
Select the connector used for the input signal.
15. ANALOG INPUT
XLR/TRS Phone Input Connector (Analog Input)
This is for connecting XLR or
TRS phone plugs.
Both balanced and unbalanced
connections are possible.
* The pin assignment for the
connector is as shown below.
Before making any connections,
make sure that this pin
assignment is compatible with
that of all your other devices.
16. Thru (Digital Out) Connector
When connecting multiple DM-5 monitors with digital
signals, this connector is used for output to the second DM-5.
XLR type
Phone type
(Unbalanced)
TRS
phone type
(Balanced)
1: GND
2: HOT
3: COLD
GND (SLEEVE)
HOT (TIP)
COLD (RING)
● Precautions When Connecting and Turning on the Power
• To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn off
the power on all devices before making any connections.
• Once the connections have been completed, turn on
power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other
devices.
(When turning the power off, reverse this procedure.)
<Connected devices → DM-5>
• This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required before
the unit will operate normally.
Using Two DM-5 Monitors for Stereo Sound
DV-7
CD Player, MD Player, etc.
DIGITAL OUT
DIGITAL IN
(COAXIAL)
(OPTICAL) THRU
(DIGITAL OUT)
DIGITAL IN
(COAXIAL)
Select
Example for
Using Analog Input Connectors
Example for
Using Digital Input Connectors