Radio Shack PDCD810 - Manual (Page 6)

- 5 -
17. Seamless Loop (2 set)
There is A, B/LOOP/ EXIT, RELOOP buttons.
1. A BUTTON---“start point” (A point. Also, Cue 1 could be a
A point) After setting up the A point, the red Led light up!
2. B/LOOP/ EXIT BUTTON: ---“ End point”(B point). Press the
B /LOOP button to set up the B point and start the loop
playback automatically. Loop lights on the display and the 3
LEDs flash. Press this button again to exit the LOOP
playback.
3. RELOOP BUTTON
Return to the loop playback by pressing the RELOOP while
in performance. However, if your want to return to loop
playback, you can press RELOOP BUTTON.
4. Change “ START POINT” and” END POINT” by pressing
the A& B/ LOOP/ EXIT button again.
The interval between A and B point must be more than 20
frames; otherwise, the B point will be canceled, then LOOP
function disappear and LOOP fades on the display.
18. RELAY
Press the “RELAY” button to activate. When one unit is in
play mode, and the other unit is in “pause” mode; pause the
playing unit, the other unit will automatically start to play.
19. PROGRAM BUTTON
You can program the track you want. While the unit is
stopped, pressing the PROG button first to enter memorized
mode, by pressing the skip buttons to select the tracks you
want to order and then press the PROG button again to
compete set up per track. The max tracks you can program
are 30 tracks. While playing programmed tracks, the LED of
PROG lights up. While the unit is stopped, open the tray
disc or turn off the power, the program will be exited.
20. BPM BUTTON
To get the BPM number manually.
21. Direct Access Key(0~9)
To select the number of the track you would like to play.
22. CONNECTOR PORTS
The 8-pin termination permits the connection of the control
unit to the main unit.
23. SLEEP:
Leave the unit unused for 30 minutes; the machine will shut
off automatically.
Connections
Typical connections with a mixer is illustrated below. Please use it for reference.
* Connect the connection cords to the line inputs of your mixer.
* The connection cords and the remote control connection cable are supplied with the main unit.
* Be sure to use the remote control connection cable which has been supplied. Use of another cable type might cause damage.
230V 50Hz 115V 60H z