Ryobi SA60 - Manual (Page 13)

Page 13
WARNING:
Do not allow familiarity with the drill to make you care-
less. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
CHARGING YOUR DRILL-DRIVER
This tool has been shipped in a low charge condition to
prevent possible problems. Therefore, you should charge it
overnight prior to use.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (drilling followed by re-
charging) for them to become fully charged.
TO CHARGE MODEL SA60
See Figure 7.
■ Charge only with the charger provided.
■ Connect charger to the tool by inserting charger plug
into input jack. Note: Input jack is located at rear of
tool.
■ Make sure power supply is normal household volt-
age, 120 Volts, 60 Hz, AC only.
■ Connect charger to power supply.
TO CHARGE MODEL SA720
See Figure 8.
■ Charge only with the charger provided.
■ Connect charger to the battery pack by inserting charger
plug into input jack. Note: Input jack is located at rear
of battery pack.
Note: Battery pack for Model SA720, can be removed
from the drill to be charged. To remove battery pack
from drill, refer to “To Remove Battery Pack from Model
SA720” later in this manual.
■ Make sure power supply is normal household volt-
age, 120 Volts, 60 Hz, AC only.
■ Connect charger to power supply.
MODEL SA60 AND SA720
See Figures 7 and 8.
■ The charge indicator light (LED) indicator, which is
located on rear of drill, will light up when charger is
properly connected to power supply. This red light indi-
cates your battery is charging and will remain on until
charger is disconnected from power supply.
Note: During the two year warranty period on drill
Model SA720, if the charge indicator light (LED) fails to
come on or goes out while charging battery pack, re-
turn charger and battery pack to your nearest autho-
rized service center for repair or replacing. If you have
drill Model SA60, return charger to service center.
OPERATION
Fig. 7
CHARGER
CHARGE
INDICATOR
LIGHT (LED)
CHARGER
PLUG
INPUT
JACK
MODEL SA60
MODEL SA720
Fig. 8
CHARGER
CHARGE
INDICATOR
LIGHT (LED)
INPUT
JACK
BATTERY
PACK
■ ■ ■ ■ ■ After normal usage, 3 hours or less of charging time is
required to fully recharge battery pack. Note: If battery
pack is completely discharged, 6 hours or longer of
charging time is required to fully recharge battery
pack.
■ The charger housing and the tool handle will become
slightly warm to the touch while charging. This is nor-
mal and does not indicate a problem.
■ DO NOT operate drill while it is connected to the charger.
The driving ability will not increase.
■ DO NOT place charger in an area of extreme heat or
cold. It works best at normal room temperature.
■ When battery pack has been charged, disconnect
charger from power supply. This practice will increase
battery life.