Renesas M16C/26A - Manual (Page 12)

• Select FF000 for the Firmware location for the
program. It is recommended that the E8a
firmware location is towards the top of the
memory map.
• Select 0B00 for the Work RAM location. It is
recommended that the Work RAM is towards the
top of the memory map.
• Ensure that the checkbox ‘Debugging of program
that uses WDT’ is not checked.
• Click <Next>.
• Only ‘Single-Chip Mode’ is available.
• Clear ‘PM10 (b0 of 000005H) is ‘1’.’
• Click <Finish>.
• The Flash Memory write program is downloaded.
• The Output window in High-performance
Embedded Workshop will state ‘Connected’
Now is a good time to save the High-performance Embedded Workshop session.
Select ‘File’ | ‘Save Session’.
If you have changed any workspace settings now is a good time to save the workspace.
Select ‘File’ | ‘Save Workspace’.
8