Renesas SH7201 - Manual (Page 11)

Chapter 6. User Circuitry
6.1. Switches
There are four switches located on the CPU board. The function of each switch and its connection are shown in Table 6-1.
Switch Function Microcontroller
RES When pressed; the CPU board microcontroller is reset. RESn, Pin 2
SW1/BOOT* Connects to an IRQ input for user controls.
The switch is also used in conjunction with the RES switch to place
the device in BOOT mode.
IRQ0, Pin 59
(Port C, bit 22 )
SW2* Connects to an IRQ line for user controls. IRQ1 , Pin 58
(Port C, bit 23)
SW3* Connects to an IRQ line for user controls. Also connects to the ADC
trigger input. The option is a pair of 0R links. For more details on
option links, please refer to Sec 6.6.
IRQ2, Pin 57
(Port C, bit 24)
Table 6-1: Switch Functions
*Refer to schematic for detailed connectivity information.
6.2. LEDs
There are six LEDs on the CPU board. The green ‘POWER’ LED lights when the board is powered. The orange BOOT LED indicates the
device is in BOOT mode when lit. The four user LEDs are connected to an IO port and will light when their corresponding port pin is set low.
Table 6-2, below, shows the LED pin references and their corresponding microcontroller port pin connections.
LED Reference (As
shown on silkscreen)
Microcontroller Port Pin
function
Microcontroller Pin
Number
Polarity
LED0 Port D bit 13 108 Active Low
LED1 Port C bit 13 68 Active Low
LED2 Port C bit 20 61 Active Low
LED3 Port C bit 21 60 Active Low
Table 6-2: LED Port
6.3. Potentiometer
A single turn potentiometer is connected to AN0 of the microcontroller. This may be used to vary the input analog voltage value to this pin
between AVCC and Ground.
7