ZANKER KBB 24001 SK - Manual (Page 22)

Problem Possible cause Solution
There is too much frost and
ice Products are not wrapped properly Wrap the products better
Doors are not shut properly or do not
close tightly Check if the doors close well and the
gaskets are undamaged and clean
The Temperature Regulator may be
set incorrectly Set a warmer temperature
It is too warm in the freezer Temperature Regulator may be set
incorrectly Set a lower temperature
The door does not close tightly or it
is not shut properly Check if the door closes well and the
gasket is undamaged and clean
Large quantities of food to be frozen
were put in at the same time Insert smaller quantities of food to be
frozen at any one time.
Food placed in the appliance was
too warm Allow food to cool to room temperature
before storing.
Products to be frozen are placed too
closely to each other Place the products in a way so that
cold air could circulate among them
It is too cold inside the freez-
er Temperature Regulator may be set
incorrectly Set a warmer temperature
The appliance does not work
at all. The appliance does not
cool at all. Neither cooling
nor lighting works The appliance may be switched off Switch on the appliance
Plug is not connected to the mains
socket properly Connect the mains plug properly
Power does not reach the appliance Try connecting another electrical de-
vice to the power outlet
There is no voltage in the mains
socket (try to connect another appli-
ance into it) Call an electrician
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
1. Remove the
screw from the
lamp cover.
2. Remove the
lamp cover (refer
to the illustra-
tion).
3. Replace the
used lamp with a
new lamp of the same power and specifically de-
signed for household appliances (the maximum
power is shown on the lamp cover).
22