Ryobi P211 - Manual (Page 17)

16 17
USING THE AUXILIARY HANDLE ASSEMBLY
See Figures 14 - 15.
An auxiliary handle is packed with the drill for ease of opera-
tion and to help prevent loss of control. The handle can be
mounted on the opposite side for left or right hand use.
ADJUSTING THE AUXILIARY HANDLE
ASSEMBLY
See Figure 14.
To adjust the auxiliary handle assembly.
n
Loosen the handle assembly by turning the handle coun-
terclockwise.
n Insert the auxiliary handle assembly in the desired operat-
ing position.
n Securely tighten by turning the auxiliary handle clock-
wise.
NOTE: Be sure the auxiliary handle is securely tightened
against the depth stop rod clamp. This secures the depth
stop rod at the desired depth of cut. It also secures the
auxiliary handle.
ADJUSTING THE DEPTH STOP ROD
See Figure 15.
The depth stop rod helps control the depth of drilled holes.
For convenience and ease of starting threads, the hex nut
has been trapped inside the molded slot in the auxiliary
handle. To adjust the depth stop rod.
n
Lock the switch trigger by placing the direction of rotation
selector in the center position.
n Loosen the auxiliary handle assembly by turning the knob
counterclockwise.
n Adjust the depth stop rod so that the drill bit extends be-
yond the end of the rod to the required drilling depth.
n Tighten the auxiliary handle assembly by turning the knob
clockwise.
NOTE: When properly installed, the teeth on the depth stop
rod should be aligned with the teeth indicator on the depth
stop rod clamp.
Fig. 14
Fig. 15
TO
TIGHTEN
DRILLING
DEPTH
DRILL BIT
TO INCREASE
DRILLING DEPTH
AUXILIARY HANDLE
ASSEMBLY
DEPTH STOP
ROD CLAMP
TO
LOOSEN
NOTCH
EARS
PLATE
TO DECREASE
DRILLING DEPTH
TO
LOOSEN
TO
TIGHTEN
DEPTH
STOP ROD
TEETH
SCALE
OPERATION