Remington LNT-2 - Manual (Page 15)

15
108539 www.desatech.com
FIGURES/FIGURAS/
FIGURES
Continued/Continúa/Suite
Figure 21 - Depth Gauge Tool On Chain
Figura 21 - Calibrador de medida de profundidad
en la cadena
Figure 21 - Position de l’outil pour limiteur de
profondeur sur la chaîne
Figure 22 - Round Off Front Corner Of Depth
Gauge
Figura 22 - Redondeo del ángulo anterior de la
medida de profundidad
Figure 22 - Arrondir le coin avant du limiteur de
profondeur
Front Corner/Ángulo
anterior/Coin avant
.025"
.635 mm
Flat File/Escofina plana/Lime plate
Depth Gauge Slot/
Ranura de medida de
profundidad/Fente du
limiteur de profondeur
Depth Gauge Tool/
Calibrador de medida
de profundidad/Outil
pour limiteur de
profondeur
Depth Gauge/Medida de
profundidad/Limiteur de
profondeur
®
IMPORTANT: Read and understand this
manual before assembling or operating
this chain saw. Improper use of saw can
cause severe injury. Keep this manual
for future reference.
UNPACKING
1. Remove all items from carton.
2. Check all items for any shipping damage. If you find
any damage or if any parts are missing, promptly
inform dealer where you bought chain saw.
CHAIN SAW NAMES AND
TERMS
Bucking Process of cutting a felled tree or log into
lengths.
Felling Process of cutting down a tree.
Felling Cut Final cut when felling a tree. Make this
cut on opposite side of tree from notching cut.
Front Handle Located at front of saw body.
Front Hand Guard Shield between front handle and
guide bar. Protects left hand while using saw.
Guide Bar Metal bar that extends from saw body.
The guide bar supports and guides chain.
Guide Bar Nose Tip or end of guide bar.
Kickback Quick backward and upward motion of
guide bar. Kickback may occur when tip of guide
bar touches an object while chain is moving. The
guide bar will kick up and back towards operator.
Limbing Process of cutting limb(s) from a felled tree.
Low-Kickback Chain Chain that reduces chance of
kickback as required by ANSI B175.1.
Normal Cutting Position Stance used while mak-
ing bucking and felling cuts.
Notching Cut Notch cut in tree that directs fall of tree.
Oiler Control System for oiling guide bar and chain.
Power Head Chain saw without chain and guide
bar. Also known as saw body.
Pushback (Kickback, Pinch) Rapid pushback of chain
saw. Pushback may occur if chain along top of guide
bar is pinched, caught, or contacts a foreign object.
Rear Handle Handle located at rear of saw body.
Reduced Kickback Guide Bar Guide bar that re-
duces chance of kickback.
ELECTRIC CHAIN SAW
Continued