Roland Prelude - Manual (Page 14)

14
Introduction
Non-Rewritable memory
Preset memory
Data in Preset memory cannot be rewritten. However, you can
call up settings from preset Performances into the temporary
area, modify them and then store the modified data in
rewritable memory.
USB memory
You can back up your settings to USB memory in the following
units of data. (p. 48)
• Sound/System
User Performances, System settings
• Style
User Styles
• Song
User Songs
• All
Style and Song in addition to the Sound/System data
listed above
To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
When connection cables with resistors are used, the volume
level of equipment connected to the input (EXT INPUT jack)
may be low. If this happens, use connection cables that do not
contain resistors.
1. Make sure that the [POWER] switch is off.
2. Move the VOLUME knob all the way to the left to minimize
the volume.
3. Connect the included power cord to the included AC
adaptor.
The indicator will light when you plug the AC adaptor into
an AC outlet.
fig.ACadap.eps
Place the AC adaptor so the side with the indicator (see
illustration) faces upwards and the side with textual
information faces downwards.
Depending on your region, the included AC adaptor may be a
different type than the one shown above. If so, omit step 3 and
proceed.
4. Connect the AC adaptor to the DC IN jack on the Prelude’s
rear panel, and then plug the AC adaptor into an electrical
outlet.
To prevent the inadvertent disruption of power to your unit
(should the plug be pulled out accidentally), and to avoid
applying undue stress to the AC adaptor jack, anchor the
power cord using the cord hook, as shown in the illustration.
Making Connections
Connecting the AC Adaptor
to an AC outlet
AC adaptor Power cord
Indicator
Prelude_e.book Page 14 Wednesday, January 14, 2009 2:18 PM