Roland VS-1824 - Manual (Page 93)

93
Using Effects
Using Effects
Inserting the Same Effect into Another Track as
Well
If in step 7 you selected “Ins” or “InsS,” that effect cannot be inserted into
another channel/track. If you chose “InsL” or “InsR,” you can use the other
effect on another channel or track with Insert.
fig.4-14
If You Wish to Use the Same Effect Both as Loop
and Insertion
It is not possible to use the same effect for both insertion and loop.
Even if the “FXIns” parameter is set to “Ins,” the “FX Sw” parameter can be
set to either “Pre” or “Pst.” This is because the VS-1824 is able to send the
signal of the FX bus not only to the effect but also to another output jack.
For example if you insert FX2 into track 1, the FX2 bus will not be used (it
will be vacant). In this situation if you set the track 2 “FX2 SW” to “Pst,” the
track 2 signal will be sent to the FX2 bus, but it will not be sent to the effect
itself (FX2). Since the signal of the FX bus can be assigned to the outputs
Digital out 1/2, AUX out A/B, Master, and Monitor, you can make settings
so that the signal of each track is sent from separate outputs. In other words
if the effect (FX2) is inserted, you can use the unused FX bus (FX2) as an
AUX bus.
fig.4-15_80
EQ
(2band, 3band)
FX
Ins
L
R
L
R
EQ
(2band, 3band) FX
InsS
L
R
L
R
EQ
(2band, 3band) FX
InsL
L L
EQ
(2band, 3band)
FX
InsR
R R
EFX1 EFX1 FX1
FX2
L R L R L R L R
MIX FX1 FX2 AUX1
Internal BUS
Level
(Fader)
EQ
(2band, 3band)
FX1
Sw
Send
Level Pan
FX2
Sw
Send
Level
Pan
AUX1
Sw
Send
Level Pan
FX2
Pan
MIX
Sw