Raymarine RAYCHART 420D - Manual (Page 64)

Chapter 4: Setting Up the Chartplotter 4-3
Menu Options Factory New
Default Setting
DATE FORMAT DD/MM/YY DD/MM/YY
MM/DD/YY
TIME OFFSET UTC or local offset value UTC
up to ±13 hours in 1-hr steps
LANGUAGE MULTI-LANGUAGE ENGLISH
SIMULATOR OFF/ON OFF
SIMULATED SOG 00 Kt to 99 Kt in 1 Kt steps 00 Kt
SIMULATED COG 000° to 359° in 1° steps 000°
Bearing mode
The mode (MAGnetic or TRUE) of all the bearing and heading data displayed.
This is indicated by M or T in the BRG or COG field of the Chart status bar.
Key beep
This setting controls audible feedback resulting from operation of the keys.
Note: Alarms remain active.
Units
You can set the units for distance, speed and depth . The units you set will be
used to display all data. However, the distance units do not affect the chart scale,
which is always in nautical miles.
Variation
The variation value is the difference between True and Magnetic direction data
for heading or bearing values. The Magnetic value is derived from True by
applying the user selected value of variation.
The variation is varied in 1° steps to 30° East or West. Press trackpad right to
move the value eastward, or left to move it westward. The selected value is
retained when the unit is switched off. The Default value is zero.
Date format
Set your preferred date format (DD/MM/YY or MM/DD/YY). The selected
setting is retained when the unit switched off. The Default is DD/MM/YY.