RocketFish RF-QX5 - Manual (Page 7)

7 RF-QX5 Noise Cancelling Wireless Headset
Pairing the headset with a compatible phone
Pairing is the process of linking the headset with a Bluetooth-enabled
mobile phone. After you pair the headset with a phone, you can only
use the headset with the paired phone. If you want to use the
headset with a different phone, you must repeat the pairing process
with the new phone. The headset can be paired with up to eight
compatible phones, but it can be connected to only one phone at a
time.
To pair the headset with a compatible phone:
1 Make sure that the compatible phone is turned on and within 33 feet
(10 meters) of the headset.
2 Turn on the headset and make sure that the battery is fully charged.
3 Press and hold the power/send/end button for about four seconds. The
indicator rapidly flashes yellow-green.
4 Release the button. The headset is now in pairing mode.
5 Activate the Bluetooth connection from the phone. See the
documentation that came with the phone for instructions.
6 Set the phone to start searching for Bluetooth devices.
7 Select RF-QX3 from the list of found devices displayed on the phone.
8 If neccessary, enter a PIN code 0000 to pair and connect the headset with
your phone. With some phones, you need to make a connection
separately after pairing.
Disconnecting the headset from the phone
To disconnect the headset from the phone:
• Turn off the headset.
Or,
• Disconnect the headset in the phone’s menu.
Or,
• Move the headset more than 33 feet (10 meters) away from the phone.
Note: You do not need to delete the pairing with the headset to disconnect the
headset. When you reconnect the headset to a phone it has be paired with, you do
not have to enter the code 0000 again.