Rinnai RCE-229A - Manual (Page 27)

E R R O R M E S S A G E S
CODE DISPLAYED FAULT REMEDY
Tilt Switch Activated
Turn heater ON,
after setting heater upright.
Miss Ignition
Check gas is turned ON.
Service call if repeated.
Flame Failure
Ventilate the room.
Service call if repeated.
Back Fire Sensor Activated
Turn heater OFF, after a while ON
again. Service call if repeated.
Overheat
Clean filter.
Service call if repeated.
Room Overheat Service call.
Power cut
Turn heater OFF,
then ON again.
This heater has the ability to check its own operation continuously. If a fault occurs, an Error Message will flash on
the Digital Display of the control panel. This assists with diagnosing the fault, and may enable you to overcome a
problem without a service call. Please quote the code displayed when inquiring about service.
If you see other codes displayed, contact Rinnai or your nearest service agent and arrange for a service
call.
In all cases, you may be able to clear the Error Message simply by turning
the heater OFF, then ON again. If the Error Message still remains or returns
on the next operation, contact RInnai or your nearest service agent and
arrange for a service call.
2 7