RCA CC6364/CC6374 - Manual (Page 15)

Connections & Setup
Chapter 1 13
Insert a cassette tape
1. Make sure the camcorder is connected to a
power supply.
2. Open the LCD monitor fully or adjust the
viewfinder.
3. With the camcorder set to A (automatic
record), slide the EJECT switch until the
cassette tape holder opens. Don’t force the
camcorder open.
4. Insert a tape with the tape wheel facing up and
the tape window facing out.
Notes:
• Make sure the tape is not slack when
loading the cassette tape. If there is any
slack, turn the wheel on the cassette
tape in the direction of the arrow to
take up the slack.
• Make sure the Erase Protection tab is in
the position that allows recording. If
not, slide the tab. Some tapes have
removable tabs. If the tab has been
removed, cover the hole with adhesive
tape.
5. Push on the area marked CLOSE until the
cassette tape holder locks into place. (PAUSE
appears on the LCD or in the viewfinder.)
Notes:
• You can’t open the cassette tape holder
unless a power supply is attached.
• The cassette tape holder can’t be
opened while the camcorder is in the
record mode.
Caution: Closing the LCD monitor while the
cassette tape holder is still open may
damage the LCD monitor.
CHARGE
STOP R RETAKE F
LIGHT
OFF AUTO ON
COUNTER R/M FADE/W
IPE
P.
AE
DIGIFECT
POWER REFRESH
EJECT
EJECT switch
STOP R RETAKE F
LIGHT
OFF AU TO ON
COUN TER R/M
FADE/WIPE P . AE DIGIFECT CHARGE VIDEO REFRESH EJECT
BATTERY
RELEASE switch
Area marked
CLOSE
Tape window
Tape wheel
Cassette tape holder