ResMed Passover User Manual

Page 2

Advertising
background image

5 Check that both the short and long air tubing are securely connected to the

humidifier and the flow generator. The humidifier is now ready to use.

C

ONNECTING

THE

F

LOW

G

ENERATOR

1 Position your flow generator on top of the humidifier. The front of the

flow generator should sit between the inlet and outlet of the humidifier.

3 Fit the wide end of the outlet

connector onto the humidifier
outlet and push it into place.

Fill line

2 Connect the short air tube from the

flow generator to the humidifier.

4 Connect one

end of the
long air
tubing to the
outlet
connector,
and attach
your mask to
the other end.

1.

1.

1.

1.

1.

2.

2.

2.

2.

2.

3.

3.

3.

3.

3.

4.

4.

4.

4.

4.

F

ILLING

THE

H

UMIDIFIER

1 Ensure that the humidifier is

clean.

2 Do not fill the humidifier with hot

or chilled water - use room
temperature water.

3 Hold the humidifier upright and

pour water through either the inlet
or the outlet until it reaches the
fill line (as shown opposite).

4 Fill the humidifier with fresh

water every night.

C

LEANING

I

NSTRUCTIONS

D

AILY

Clean the humidifier every day after you use it. Follow these steps:

1 Ensure that the flow generator is switched off. Disconnect the short

air tubing. Remove the outlet connector from the humidifier. Lift the
flow generator off the humidifier.

2 Drain any remaining water from the humidifier.

3 Wash the humidifier, outlet connector, and air tubing in warm water, using

a mild detergent. Do not use hot water. Partly fill the humidifier and
shake vigorously.

4 Rinse thoroughly with clean water and allow the humidifier to air dry

completely in a warm place (not in direct sunlight).

W

EEKLY

Clean the humidifier thoroughly every week as follows:

1 Soak the humidifier in a solution of one part vinegar and 3 parts warm

water for 1 hour.

2 Rinse thoroughly with clean water and allow the humidifier to air dry

completely in a warm place (not in direct sunlight).

Do not use bleach, chlorine-, alcohol-, or aromatic-based solutions on the
air tubing or connector as these could cause some deterioration in the
materials.

Do not hang the air tubing in direct sunlight as the tubing may harden over
time and eventually crack.

C

AUTION

:

Advertising