RCA D52W23 - Manual (Page 34)

32 Chapter 4
Using the Menu System
Sound Menu
The Sound menu lets you adjust audio output. To access the Sound menu, press
MENU on the remote, and then select Sound from the main menu.
This section describes the items available in the Sound menu.
Sound settings The Sound settings submenu contains the following items: Sound settings Sound settings
Left & Right balance Use the left or right arrow button to center the bar Left & Right balance Left & Right balance
under the arrow to balance the left and right speakers.
Amplifi er Use the left or right arrow button to select
Amplifi er Amplifi er External (if your HD
Monitor is using external amplifi er only) or Internal (if your HD Monitor is
using the speakers in the HD Monitor).
Subwoofer Set the HD Monitor’s subwoofer to
Subwoofer Subwoofer External, if the HD Monitor
is using an external subwoofer; or None.
Sound type Press the right arrow button to scroll through the available audio type type
types, which control the way the sound comes through your speakers. The
options available vary according to the input selected.
Stereo Splits the incoming stereo audio signal into left and right channels.
Most TV programs and recorded materials have stereo audio. The word
Stereo appears in the channel banner when you tune to a program that is
broadcast in stereo.
Left and
Left Left Right Isolates either the left or right channel of the incoming Right Right
audio.
Sound Mode Press the right arrow button to scroll through the available audio Mode Mode
modes, which provide special processing through your speakers (depending on
the setting you chose as your Sound type).
Sound type Sound type
Normal Does not give any special processing, simply provides the mono Normal Normal
or stereo sound provided by the signal you're watching.
Wide Available only for mono signals. “Widens” sound from mono
Wide Wide
broadcasts and mono devices connected to your HD Monitor for a fuller,
more spacious sound.
Magic Available only for stereo signals. Gives a surround effect with more
Magic Magic
bass.
Sound logic Reduces the annoying blasts in volume during commercial logic logic
breaks, and also amplifi es softer sounds in program material. Eliminates the
need to constantly adjust the volume.
Dynamic bass Enhances your HD Monitor's low-frequency response. The
options are Off,
Off Off Medium and High.
Go back
Sound settings
Sound type
Sound mode
Sound logic
Dynamic bass
Headphone settings
Graphic equalizer
...
Stereo...
Normal...
Medium...
...
...
Sound
Go back
Left & Right balance
Amplifier
Subwoofer
External...
External...
Settings