Remington REM10PT - Manual (Page 5)

110373-01B
For more information, visit www.desatech.com For more information, visit www.desatech.com
5
5
INSTALLATION
Thermostat Sensing Bulb
Installing Heater To Wall
THERMOSTAT SENSING BULB
The thermostat sensing bulb is located inside the heater. Do not
move this bulb during installation or operation of the heater.
INSTALLING HEATER TO WALL
Marking Screw Locations
1. Determine where you will locate heater.
2. Mark two mounting screw locations on wall (see Figure 3).
Installing Two Mounting Screws
Note: Wall anchors and mounting screws are in hardware package.
The hardware package is provided with heater.
WARNING: Maintain minimum clearances shown
in Figure 3. If you can, provide greater clearances
from floor and joining wall.
Attaching To Wall Stud Method
For attaching mounting screw to wall stud
1. Drill hole at marked location using 9/64" drill bit.
2. Insert mounting screw into wall stud.
3. Tighten screw until 1/16" space (thickness of penny) is be-
tween screwhead and wall.
Attaching To Wall Anchor Method
Follow instructions below to attach mounting screws to hollow walls
(wall areas between studs) or solid walls (concrete or masonry).
1. Drill holes at marked locations using 5/16" drill bit. For solid
walls (concrete or masonry), drill at least 1
1 /
4
" deep.
2. Fold wall anchor (see Figure 4).
Figure 3 - Mounting Screw Locations
Mounting
Screw
Locations
8 7 /
8
"
Minimum To
Maintain 6"
Clearance
From Wall
7 3 /
4
"
20 1 / 4 "
Minimum To
Maintain 3"
Clearance
From Floor
FLOOR
JOINING WALL
INSTALLATION
Continued
Figure 4 - Folding Anchor Figure 5 - Popping Open Anchor
Wings For Thin Walls
Thin Walls
(1/4" to
1/2" thick)
Figure 6 - Tightening Anchors
1/16"
Space
Thin or Thick
Wall (thick
wall shown)
Solid
Wall
3. Insert wall anchor (wings first) into hole. Tap anchor flush to wall.
4. For thin walls (1/2" or less), insert red key into wall anchor.
Push red key to “pop” open anchor wings (see Figure 5).
IMPORTANT : Do not hammer key! For thick walls (over 1/2"
thick) or solid walls, do not pop open wings.
5. Tighten two screws until 1/16" space (thickness of penny) is
between screwheads and wall (see Figure 6).
Placing Heater On Mounting Screws
1. Locate two keyhole slots on back panel of heater (see Figure 7).
2. Place large openings of slots over screwheads. Slide heater
down until screws are in small portion of slots.
Figure 7 - Location Of Keyhole Slots On Back Panel Of Heater
Keyhole Slots
Removing Front Panel Of
Heater
1. Remove two screws near bot-
tom corners of front panel.
2. Lift straight up on grill guard
until it stops. Grill guard will
slide up about 1/4".
3. Pull bottom of front panel for-
ward, then down.
Figure 8 - Removing Front Panel
Of Heater